3/27/2023 0 Comments Jmri decoderpro manual![]() ![]() Select the location for your user files on your system Shows the default settings which will depend upon the system used. Include the prefix for your connection, in the case shown the "L" is default Selection if there are more than one possibilityĭrop-down list to select the command station type that JMRI will be using to send ![]() If you do not know,Ĭheck your system hardware configuration manual. To select the serial port to which your DCC interface is connected. May include a selection if there are more than one possibility. ![]() You do not know, check your system hardware configuration manual. Now select Connections and connection options display in right paneĭrop-down list with all the supported DCC manufacturers, select theĭrop-down list with all of the supported DCC system interfaces supporttedīy the manufacturer that you selected, select the interface that you are using.ĭrop-down list to select the serial port to which your DCC interface is connected. I keep master roster on the SystemĬonnections Pane (TABS are configured to the system your selected) Via loconet, PR3 (MS100 mode) and USB port. I am using a Digitrax Super Chief Command Station (radio) interfaced to the computer Now we will set up preferences for the JMRI environment with your command station. Set default actions for system message when displayedĪllows you to set your default Programmer and roster locationĪllows you to set up you Throttle preferencesĪllows you to set up a Wi Throttle settings Set default location for saving User files and Script FilesĪllows you to set Actions, Buttons, Files and Scripts that run at Start UpĪllows you to select your computer display mode Clicking on one of the items opens the options that may be set in the right sideĪllows you to select the system connection that you are using for controlling DCC and The window is split into two panes, on the left side is a list of preference groups that Operate trains equipped with DCC decoders. You will be using that system to actually program and The Preferences window provides access to the basic configuration information to connect Most importantly, you must click to finalize your settings and then re-start the program to have them take Most of rest youĬan leave at the initial or “default” settings until you find a need to change things to suit Screen where you describe how the computer will talk to the command station. (This window may open automatically the first time you run theĪs a first time user the most important information is the Connections option in the screen below, which opens the What DCC systems will DecoderPro® work with?Ĭlick on the Edit menu and then Preferences. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |